Take Care of Your Electrical Problems
If you are trying to do something on your own in terms of home improvement, you may find things to be a lot of trial and error.
But if you have electrical problems and realize that you need to undertake electrical projects to fix the issues in your home, you can't risk doing them by trial and error. You need to get them done right the first time. You should make sure you follow some of these hints to do things right the first time.
First of all, you might need to get a permit to tamper with wire or do other things in your home from your local electrical authority. You should know that some states require permits to do certain things. Check these out, for example:
- You may need a permit to alter your wiring.
- You may need a permit to put in more wiring in your home or to install an electrical light fixture, a garage-door receptacle, or to convert a fuse box to circuit breakers.
- You may need a permit to change a low-voltage system like an alarm or a computer system.
These permit laws change a lot depending on your state, so you need to make sure you don't need a permit to do certain things to your home.
You should always turn off the electrical power at the source through the circuit breaker before beginning work on your project. You will want to do this because even if you flip a wall switch, you could still have a live appliance or the socket could still be live. Do not trust the distribution panels that show which circuit is connected to which breaker. It is better to be safe than sorry.
You should make sure the circuit is dead by using a voltage tester first. You can use the assistance of someone to help you test the circuit breaker and the fuse box and not have to run back and forth the entire time. You'll want to tape the circuit breaker into the off spot so that no one tries to turn it back on while you work. You should not turn the power on until you are finished with everything.
You can turn off a switch, you cannot turn off the wires that are going into the electrical distribution panel from the outside. You should not fool around with these wires and do not go anywhere near them if you have metal with you. If you think there is a problem with these wires, you'll need to call your electric company.
Make sure not to stand in any water or on a damp floor because you could get shocked. Put a rubber mat on the ground if there is water around or if the floor is wet. You should always wear dry clothes and shoes. ABOVE ALL, call a professional electrician if you are concerned about anything related to safety.
The freelance writer Kurt Schefken is particularly passionate about themes related to cnc machines. You might come across his abstracts on used cnc electronics at http://www.insidewoodworking.com and various other sources for used cnc electronics knowledge.
Article Source: http://EzineArticles.com/?expert=Kurt_K._Schefken